The Jacks ‘R’ Better Bear Mountain Bridge Hammock is a true lay flat, sleep straight hammock. It achieves these notable results by departing from the common “gather end” design to utilize a suspension bridge technique. The hammock takes its name from the suspension bridge over the Hudson River that carries the Appalachian Trail. When the Bear Mountain Bridge was completed in 1924 it was the largest suspension bridge in the world. This is the lowest point of the entire Appalachian Trail at 127 feet above sea level.
The JRB Bear Mountain Bridge Hammock is constructed of 70D rip stop nylon material and high strength polypropylene webbing. It will comfortably accommodate individuals up to 6 foot 3 inches tall and up to 250 pounds. The primary suspension lines are 1 inch polypropylene webbing and include the unique JRB Tri-Glide for quick, easy, knot free, no hassle hanging.
The hammock comes complete with an attached bug net made of no-see-um netting that is zippered on three sides with a double pull zipper. It can be unzipped and tied back if desired when there is no bug threat. There are two personal gear pockets, one on each end wall of the hammock. And for added comfort we’ve included a re-usable, 14″ x 10″, 0.6 ounce, inflatable pillow.
The Bear Mountain Bridge Hammock comes in two models the original Deluxe model and the new Ultra Light model. On the BMBH – UL the bottom has been redesigned to be 4 inches less deep, the pad pocket is eliminated and it comes with separable webbing suspension. The four under quilt attachment loops are also eliminated and the under quilt now attaches directly to the secondary (spreader bar) rings.
For bottom insulation, use the loops on each corner (Deluxe) or the sescondary suspension rings (UL) to attach the Mt Washington or Greylock series of under quilts or any of the standard (78″x48″) JRB quilts as an under quilt (attachment instructions); or the Deluxe model is designed with a 26 inch wide pad pocket that will accommodate most camping pads.
NOTE: The aluminum spreader bars that come with the Bear Mountain Bridge Hammock are intended to withstand the compression force along their long axis caused by the suspension straps when the hammock is loaded. Lateral stresses on the spreader bars, particularly when they are under compression, will cause the bars to fail and bend, ruining the spreader bars. DO NOT try to adjust your body position in the hammock by pulling on the spreader bars. Instead grab the sides of the hammock to adjust your body position. Jacks ‘R’ Better does not recommend hanging packs or other gear from the spreader bar itself as this places unnecessary stress on the spreader bar.